OPTO 22 groov EPIC Assembly Instructions

UNPACKING YOUR LEARNING CENTER
Congratulations on your groov EPIC® Learning Center! To get started, check that you received all the following items:
groov EPIC I/O unit mounted on an acrylic stand
Pelican® equipment case
The following hardware is mounted on the acrylic stand:
• GRV-EPIC-PR2 (groov EPIC processor)
• GRV-EPIC-PSPT (pass-thru power adapter)
• GRV-EPIC-CHS4 (4-module mounting chassis)
• Load Panel: 1 multi-color LED strip panel light (red, blue, and green); 2 illuminated push buttons; 1 potentiometer; 1 temperature probe
connector; 1 Sonalert alarm
The following printed software keys are included:
• groov Activation Key
•
Ignition Edge® Development License Key
You need to supply the following:
•
An Ethernet cable
• 110 to 240 VAC power
•
A network that connects the Learning Center and a computer.
NOTE: To keep the acrylic stand clean and fingerprint-free, use a plastic cleaner (like Plexus® plastic cleaner) instead of a glass cleaner.
After you verify that you have all the equipment, go to the next page to begin assembling your Learning Center!
OPTO 22 • 800-321-6786 • 1-951-695-3000 • www.opto22.com • sales@opto22.com
© 2023 Opto 22. All rights reserved. Dimensions and specifications are subject to change. Brand or product names used herein are trademarks or registered trademarks of their respective companies or organizations.
groov EPIC Learning Center 2 Assembly
• Module 0, GRV-IACDCTTL-24
• Module 1, GRV-ODCI-12
• Module 2, GRV-MM1001-10
12 V Power adapter & cord
ICTD Temperature probe with resistor
groov EPIC Learning Center 2 Assembly
(this document; Form 2409)
Form 2409-231219
PAGE 1