General Specifications - Creative Sound Blaster Pro Getting Started

2-6
If the test program stops or displays an error message when it is checking
the Audio interface's base 1/0 address, interrupt, and DMA channel, it may
be due to a conflict between the audio card and another peripheral card.
To resolve the conflict, you have to change the settings of your audio card.
(See Appendix Bon how to change the settings and resolve the conflicts.)
If there is no sound output during the test, check the following:
D Speakers are connected to the card's audio output connector.
D Volume control knob is set at mid-range.
D No hardware conflicts between the audio card and another
peripheral card.
The built-in stereo power amplifier has a maximum output power
of four watts per channel for four ohm speakers and two watts per
channel for eight ohm speakers. Do not play at maximum if your
speakers cannot handle this power.
Sound Blaster Pro (Sony Interface) Getting Started
A
General Specifications
FM stereo music synthesizer producing 20 voices with 2 FM operators.
Built-in 4 watts stereo power amplifier that can drive the headphones
or speakers.
Stereo digitized audio playback capability
D Plays back all kinds of digitized sounds such as speech, music and
special effects through the two 8-bit Digital-to-Analog Converters
(DACs).
D Variable sampling rate from 4 kHz to 44.1 kHz.
D Hardware ADPCM decompression (2: 1, 3: l, and 4: 1 ).
D DMA or CPU transfer mode.
Stereo digitized audio record capability
D Digitizes and records any kind of sound through the microphone,
line-in, and CD-audio.
D Sampling rate from 4 kHz to 44.1 kHz (mono) or 11 kHz to 22.05
kHz(stereo)
D DMA transfer mode.
Built-in Digital/ Analog Mixer
D Software programmable digital/analog mixer.
D Mixes stereo DAC, FM music, CD-audio, Line-In, Microphone
input, and Master Volume during playback.
Built-in Microphone Jack and Amplifier
D Automatic Gain Control that automatically adjusts sound input
level.
Built-in Master Volume Control
General Specifications A-I