Advertisement
Technical Specifications
Calibrating the Height
Press the DOWN button until the desk reaches the lowest position.
Measure the height from the floor to the top surface of the desktop.
If the displayed height does not match your measurement, follow these steps:
Press the DOWN button until display flashes "ASR".
Press the "S" button until the numeric display begins flashing.
Use the UP/DOWN buttons to set the value so that it matches your measured height.
Once display changes back to "ASR", press DOWN button until the desktop lowers and rises slightly.
Setting the Upper/Lower Limits
The desk is designed to go to its minimum and maximum height limits, allowing for the widest possible
range. If you prefer a narrower range, follow these steps to adjust the upper and lower limits:
To Set a new maximum desk height:
Press the UP or DOWN button to move the desk to the desired maximum height.
Press the "S" button once, and then the UP button once. The Display will flash "S-"
Press and hold the "S" button until the Display shows "999", and then changes to numeric value of
new upper limit.
To Set a new minimum desk height:
Press the UP or DOWN button to move the desk to the desired minimum height.
Press the "S" button once, and then the DOWN button once. The Display will flash "S-"
Press and hold the "S" button until the Display shows "000" and then changes to numeric value of new
lower limit.
Removing adjusted maximum and minimum heights:
Press and hold the "S" button until the display flashes "S-".
Within 5 seconds, press the "S" button again and hold for 2 seconds. The display will change to "555"
and return to the current numeric height setting. Limits are now removed.
Note: If memory settings were previously set outside of the new minimum and maximum height
settings, they will default to the new minimum and maximum settings. To set new minimum and
maximum height settings outside of the current settings, you will need to first remove the current
minimum and maximum settings.
14105 Avalon Boulevard, Los Angeles, CA 90061
Height Range
23.5" - 49" (excluding desktop)
Base Width
42" min. - 74" max
Travel Speed
1.5" per second (no load)
Weight Capacity
1000N
Duty Cycle
10%. Max. 2 mins on, 18 mins o
Soft start / stop
Adjustable Leveling Studs
4 Memory presets
|
Tel 310-353-7100
www.VersaTables.com
|
Fax 310-353-7109
Advertisement
