Advertisement
Assembly
Step 4
Slide the two center rails into the two end frames ensuring:
a) Center rail slots face inward
b) Center rail slots are closer to the top edge
when the assembly is upside down
(as shown in inset)
Step 5
For each leg, attach a foot with
four (4) M6x14 Machine screws
and tighten in a cross pattern.
Step 6
Place desktop with pre-drilled holes and
pre-installed inserts facing up.
Adjust the width of the desk base by
sliding the two end frames outward.
Align the holes on the desk base and
the underside of the desktop.
Attach the desk base to the desktop
using eight (8) 1/4-20 Phillips Bolts for
the side bracket holes going into the
inserts. Use three (3) M5x20 Wood
Screws for the end frame holes going
into the desktop.
14105 Avalon Boulevard, Los Angeles, CA 90061
x8
1/4-20 Phillips Bolt
|
Tel 310-353-7100
www.VersaTables.com
x4
M6x14 Machine screw
x3
M5x20 Wood Screw
|
Fax 310-353-7109
Advertisement
