Using And Configuring Standby Mode - Toshiba TECRA GMAD00134010 User Manual

5 Click Apply.
6 Click OK.
Once the computer is configured, you can place it into Hibernation
mode by either pressing the power button or closing the display
panel, depending on the Hibernation options set.
Starting again from Hibernation mode
To start up the computer from Hibernation mode, press the power
button until the on/off light glows blue. The computer returns to the
screen(s) you were using.
If you put the computer in Hibernation mode by closing the display
panel, you can start it again by opening the display panel.

Using and configuring Standby mode

To turn off the computer using the Standby command, click Start,
Turn off computer, and then select Stand By.
(Sample Image) Turn off computer Windows
The computer saves the status of all open programs and files, turns
off the display, and enters into a low-power mode. The on/off light
blinks amber indicating the computer is in Standby mode.
Configuring Standby mode options
You can place the computer into Standby mode by either pressing
the power button or closing the display panel. You can also specify
an amount of time after which the computer automatically goes into
Standby mode.
To use any of these methods, you first need to enable them in
Toshiba's Power Saver utility.
1 Click Start, Control Panel, and then Performance and
Maintenance.
2 Click the TOSHIBA Power Saver icon.
3 Click the Setup Action tab.
Getting Started
Turning off the computer
®
dialog box
77