Table of Contents
Advertisement
TX1414W Wind Speed and Thermo-hygro
TX141TH-BCH can be added on channel 2 or channel 3 for additional
temperature/humidity readings.
The above 433MHz sensors will read to this Professional weather station.
You can add up to two TX141TH-BCH sensors for extra temp/humidity
readings on channels 2 or 3. (Wind Sensor uses channel 1).
1. Remove the battery cover from all the sensors (leave battery covers off until all
sensors are received by the wind station).
2. Set the first additional sensor to Channel 2 and insert 2 AA batteries.
3. Set the second additional sensor to Channel 3 and insert 2 AA batteries.
4. Hold the DOWN arrow button on the wind station for 5 seconds to search for
sensors.
5. Press the TX button on each sensor.
6. When connection is established, the temperature & humidity for each of the
selected channels will appear.
7. Install the battery covers on each sensor.
8. Keep sensors and the wind station 5-10 feet apart for 15 minutes to establish a
solid connection.
9. After 15 minutes, place the remote sensors in appropriate shaded locations.
10.Press and release the DOWN arrow button to view channels 1, 2 or 3 on the
wind station when multiple sensors are used.
Note: If only one sensor is connected, the other channels will show dashes for
temperature and humidity.
The wind station will automatically rotate through the channels for all
connected sensors when the circling arrow icon shows.
Press and release the DOWN arrow button to lock the wind station into one
channel.
Then press the DOWN arrow button to view channels individually.
DASHES SHOWN FOR OUTDOOR TEMPERATURE/HUMIDITY/WINDSPEED
Dashes means the unit have lost connection between the display and the
outdoor sensor.
Batteries are the most common problem.
Distance/Resistance can cause loss of sensor signal. Avoid having more than 1
wall, window, tree etc., between the display and the sensor. UV coated windows
may actually reflect the signal. Stucco walls will absorb the signal.
It may be helpful to orient the weather 90 degrees towards the sensor for better
reception.
Sensors operate best when elevated at least 6 feet.
Remove the batteries from the sensor for 2 minutes. Replace the batteries in the
Thermohygro sensor and after 5 minutes press and hold the DOWN
ARROW button for 5 seconds. Wait 10 minutes. If the unit does not receive a
reading from all the sensors please try the factory reset.
La Crosse Technology, Ltd.
ADD-ON SENSORS
WIND | THERMO-HYGRO SENSOR
Page 3
Advertisement
Table of Contents
