Advertisement
洗衣前準備
Preparation of the wash cycle
衣物分類 Sort the laundry
1. 將衣物置入洗衣桶內，開機前確保機門已關閉。
Load the washing machine, close the drum door and
check that it is closed properly.
2. 注入洗滌劑，如有須要可加其他衣物添加劑。
Pour in the detergent and any additives, as described
overleaf and in the instruction manual.
3. 關閉機門。
Closed the lid.
4. 旋動選擇旋鈕選取所需功能。選取程序的操作時間顯示於屏
幕上。開始/暫停指示燈會閃動。所選取轉速的指示燈會亮
起。本機將會於程序完結，或已設定預校洗衣程序後約 15
分鐘自動熄機。如須再次開啟本機，將程序選擇掣旋至 Off
字樣，後再重新選取所須程序。
Turn the programme selector to the desired programme
and temperature. The time display shows the duration of
the chosen programme (in hours and minutes), and the
lamp next to the Start/Pause button flashes. The indicator
lamp of the predefined spin speed lights up. If you do
not start the programe soon after having made your
choice,
the
washing
automatically after about a quarter of an hour. Switch
on
the
washing
machine
programe
selector
desired programme.
選取所須功能 Select any desired option
當所取功能組合與洗衣程序不能兼容時，相關指示燈會自動熄
滅，所選取的功能組合會自動取消。
When the combination of programme and additional option(s)
is not possible, the indication lights switch off automatically.
Unsuitable
combinations
automatically.
預洗按鈕 Prewash button
適用於污漬較多衣物。此功能操作時間會延長約 19 分鐘。
Only for heavily soiled loads (for example sand, granular
dirt). Increases the cycle time by approximately 19 min.
選用預洗功能時，切勿使用洗衣液。
Do not use liquid detergent for the main wash when
activating the Prewash option.
深層洗衣程序按鈕 "Intensive wash" button
此功能可配合洗衣專用清潔劑去除污漬，結合系統設計洗衣
模式，發揮除污劑最佳效能。
Choose this option if you use an in-wash additive for stain
removal - it will optimize the additive's efficiency to get
better wash performance and stain removal.
置入最大洗衣量，於主洗格加入洗衣專用清潔劑(切勿使用
洗衣液)。
Use with the maximum load. Add an appropriate of
in-wash additive for stain removal (powder) to the
main wash.
此功能會延長操作時間約10分鐘。宜選用氧基除污劑或漂
白水。切勿使用含氯或過硼酸鹽漂白劑。
May prolong the program by up to 10 minutes. Appropriate
for use of stain removers and bleaches on oxygen basis.
Chlorine or perborate bleaches must not be used.
額外過水按鈕 "Extra Rinse" button
洗衣過程中會加長清洗時間，從而避免留有殘餘洗衣劑。
Helps to avoid detergent residues in the laundry by
extending the rinse phase.
此功能適用於嬰兒及敏感人士清洗衣物。
Particularly suitable for washing baby laundry, for people
suffering from allergies and for areas with soft water.
machine
will
switch
again
by
turning
back
to
"Off" and then to the
of
options
are
deselected
冷水洗衣程序按鈕 "Cold Wash" button
此功能設計配合於冷水洗濯衣物時，仍可有效潔淨衣物及
達至節能效果。
Save energy used for water heating while maintaining
good wash result.
建議使用此功能洗濯污漬較少衣物。
Recomentable for lightly soiled laundry without stains.
使用此功能時，確保洗滌劑能用於冷水洗衣，溫度為 15 至
20℃。
Make sure that your detergent is suitable for cold wash
temperature (15 or 20℃).
此功能可配合適用於冷水溫度的洗衣功能。
Mainly selectable on the lowest temperature step of the
programmes.
脫水按鈕 "Spin Speed" button
每一程序已預設有指定脫水旋乾速度。
Every programme has a predefined spin speed.
按下此功能以選取不同轉速。
Press the button to set another spin speed.
如已選擇 0 轉速，則程序至最後操作時會取消旋乾轉速，祇
作免旅排水。洗衣操作期間旋乾轉速則仍持續。
If spin speed "0" is selected, the final spinning is cancelled
off
but intermediate spin peaks remain during the rinse. The
water is drained out only.
the
預校開機時間 Start Delay
預校開機時間掣為因應設定洗衣時間，例如可設指定時間於夜
間洗衣。按下預校開機時間按鈕，選取所須時間。完成選項
後，預校開機時間按鈕指示燈亮後並熄滅。
To set the selected programme to start at a later time, press
the Start delay button to set the desired delay time. The
lamp for the Start delay option button lights up, and it goes
off when the programme starts.
按下開始/暫停按鈕，預校開機時間會以倒數形式顯示。當到
達開機時間後，洗衣時間會顯示並取代開機倒數時間。
Once having pressed the Start delay button, the countdown
of the time delay begins. The time delay indication on the
display disappears when the programme starts and it is
replaced by the remaining programme time.
按下開始/暫停按鈕啟動預校開機時間後，如須再調整開機時
間，可再次按下預校開機時間按鈕遞減開機時間。使用預校開
機時間不應使用洗衣液。
Number of hours preselected can be reduced by pressing the
Start delay button again. Do not use liquid detergent when
activating this option.
如須取消預校開機時間，將洗衣程序選擇掣旋至其他程序位置
便可。
To cancel the Start delay turn the programme selector
to another position.
5
Advertisement
