Remote Control Issues - Samsung TU7000 E-Manual

The problem
The message "Connecting to
Anynet+ device..." or
"Disconnecting from Anynet+
device" appears on the screen.
The Anynet+ device won't play.
The connected device is not
displayed.

Remote Control Issues

When the remote control isn't working, these steps may help resolve the problem.
The problem
The remote control does
not work.
External devices cannot be
operated with the TV
remote control.
You cannot use the remote control when the TV is configuring Anynet+ or switching
to the TV viewing screen.
Use the remote control after the TV has completed the Anynet+ configuration or has
switched to the TV viewing screen.
You cannot use the play function when
Check whether the device supports Anynet+.
Anynet+ devices must be connected to the TV using an HDMI cable. Make sure the
device is connected to your TV with an HDMI cable. Some HDMI cables may not
support Anynet+.
Check whether the HDMI cable is properly connected.
Go to Anynet+ (HDMI-CEC)
• Settings
Scan for Anynet+ devices again.
If the connection is terminated because there has been a power failure or the HDMI
cable has been disconnected, please scan for the device again.
The connection between the remote control and the TV may be lost.
Also, if the remote control is not working or slow, the batteries might be low or dead. If this
is the case, replace the batteries. Alkaline batteries are recommended for longer battery
life.
Check the cable connection between the TV and external devices.
When the symptom persists, set it manually in
Try this!
Reset
and see if Anynet+ (HDMI-CEC)
General External Device Manager
Try this!
- 115 -
is in progress.
has been set to On.
Anynet+ (HDMI-CEC)
Source Universal Remote Setup.