Mangar AB0003 User Instructions

Adjustable Bath & Shower Chair - User Instructions
(Model: AB 0003)
The Adjustable Bath & Shower Chair by Mangar International is intended to be used in a bath or shower to
provide a stable, seated support, where a user is unable to stand for long periods. It may be used with or
without the backrest.

Contents

2 x Legs inc. 4 x captive screws.
5 x Round head screws.
5 x Saddle washers.
5 x Spring washers.
1 x Seat.
1 x Backrest.
2 x Backrest support tubes.
1 x User instructions.

Assembly

Tools required: Philips screwdriver.
Seat section (Fig.1)
1. Place the seat upside down on a flat surface
and align the legs so that the numbers
1 & 2 stamped on the legs correspond to the
numbers 1 & 2 moulded into the seat.
2. Loosely secure the four captive screws (A).
3. Fit the spring washer (B) and saddle washer
(C) to the screw (D) and insert into the centre
hole before fully tightening.
4. Fully tighten the four captive screws (A).
Backrest section (Figs. 2&3)
5. Align the holes in the backrest support tubes
with the holes in the backrest.
6. Fit the spring washers (B) and saddle washers
(C) to the screws (D) and insert into the four
holes before fully tightening.
7. Insert the backrest tubes into the guide tubes
on the underside of the seat ensuring that
the snap buttons (E) locate in the guide tube
holes.
freedom through lightweight solutions
D
B
C
2
1
E
MI0236 issue 1
A
Fig. 1
D
C B
Fig. 2
Fig. 3