THE STANDING DESK LÜFTEN Assembly Instructions

Twin column table

Advertisement

5

OPERATING INSTRUCTIONS

To adjust the height of the table, squeeze the release handle and allow table to move up or push down
on table top to lower. To cause more or less tension when lifting and lowering the table, use a wrench to
tighten or loosen the ADJUSTMENT BARREL attached to the end of the handle.
CAUTION: Brace the top with free hand when moving the table up and down to control movement.
For proper cleaning instructions go to
TheStandingDesk.com/clean
Adjustment Barrel
FOR VIDEO INSTALL INSTRUCTIONS GO TO TheStandingDesk.com/install
THE LÜFTEN
TWIN COLUMN TABLE
ASSEMBLY INSTRUCTIONS
• Twist in the GLIDES
or the (OPTIONAL)
CASTORS into the
Glides (4)
holes on the bottom
of the base.
• If not secure
OPTIONAL
enough, tighten with
Castors (4)
WRENCH.
1/2" Wrench
Adjustment Barrel

INCLUDED HARDWARE PACKAGE

1" Wood
1/2" Wood
Screw (8)
Screw (5)

INCLUDED TOOLS

m6
m8
Allen Wrench
Allen Wrench
"Note" Ideal weight capacity range for the Luften desk is 15-35lbs with a standard 350N spring. The table support is
solely intended to serve the purpose of ergonomic adjustments for your desk in accordance with the weights and measurements
given in these instructions. Any usage other than that mentioned in this document is inappropriate; the manufacturer disclaims
liability for any resulting damages. In such cases the user bears the full risk. The manufacturer cannot be held responsible for
any losses or damages resulting from unauthorized modifications of this desk.
4 / 4
FOR VIDEO INSTALL INSTRUCTIONS GO TO TheStandingDesk.com/install
TWIN COLUMN TABLE
ASSEMBLY INSTRUCTIONS
Flat Head
Socket Head
Boden Cord Clip (1)
Cap Screw (8)
Cap Screw (8)
PLEASE REVIEW these instructions completely

REQUIRED TOOLS

and verify all parts are included in this package
before beginning assembly. Do not discard
the packaging until satisfied that the product
operates properly. Assembly and operation
of this desk must be in accordance with these
assembly instructions to avoid the risk of injury.
#2 Phillips Head
1/2" Wrench
Keep these Assembly and Operation Instructions
Screwdriver
near the assembly for reference.
THE LÜFTEN
Glides (4)
OPTIONAL
Castors (4)
1 / 4

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the LÜFTEN and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for THE STANDING DESK LÜFTEN

  • Page 1 THE LÜFTEN THE LÜFTEN TWIN COLUMN TABLE TWIN COLUMN TABLE ASSEMBLY INSTRUCTIONS ASSEMBLY INSTRUCTIONS • Twist in the GLIDES or the (OPTIONAL) CASTORS into the Glides (4) holes on the bottom of the base. • If not secure OPTIONAL enough, tighten with Castors (4) WRENCH.
  • Page 2 THE LÜFTEN THE LÜFTEN TWIN COLUMN TABLE TWIN COLUMN TABLE ASSEMBLY INSTRUCTIONS ASSEMBLY INSTRUCTIONS • Remove traveling screws from both columns. • Slip the base over both the columns CAUTION: When screw is removed from the and attach the base column without the Boden cord attached, the with the SOCKET column will move in and out freely.

Table of Contents