THE STANDING DESK THE ANDERN Assembly Instructions

Mono column table

Advertisement

INCLUDED HARDWARE PACKAGE

1" Wood
1/2" Wood
Screw (4)
Screw (5)

INCLUDED TOOLS

m6
m8
Allen Wrench
Allen Wrench
"Note" Ideal weight capacity range for the Andern desk is 5-25lbs with a standard 250N spring. The table support is
solely intended to serve the purpose of ergonomic adjustments for your desk in accordance with the weights and measurements
given in these instructions. Any usage other than that mentioned in this document is inappropriate; the manufacturer disclaims
liability for any resulting damages. In such cases the user bears the full risk. The manufacturer cannot be held responsible for
any losses or damages resulting from unauthorized modifications of this desk.
FOR VIDEO INSTALL INSTRUCTIONS GO TO TheStandingDesk.com/install
Flat Head
Socket Head
Cap Screw (4)
Cap Screw (4)
TOOLS NOT INCLUDED
#2 Phillips Head
Screwdriver
MONO COLUMN TABLE
Boden Cord Clip (1)
PLEASE REVIEW these instructions completely
and verify all parts are included in this package
before beginning assembly. Do not discard
the packaging until satisfied that the product
operates properly. Assembly and operation
of this desk must be in accordance with these
assembly instructions to avoid the risk of injury.
1/2" and 5/16"
Keep these Assembly and Operation Instructions
Wrenches
near the assembly for reference.
THE ANDERN
Glides (4)
OPTIONAL
Castors (4)
1 / 4

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the THE ANDERN and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for THE STANDING DESK THE ANDERN

  • Page 1 “Note” Ideal weight capacity range for the Andern desk is 5-25lbs with a standard 250N spring. The table support is solely intended to serve the purpose of ergonomic adjustments for your desk in accordance with the weights and measurements given in these instructions.
  • Page 2 THE ANDERN MONO COLUMN TABLE ASSEMBLY INSTRUCTIONS • Remove traveling screw from column. • Attach the top plate to the column flat head cap screws and the M6 allen wrench. Flat Head Cap Screw (4) NOTE: Make sure spacer plate is between column flange and top plate.
  • Page 3 THE ANDERN MONO COLUMN TABLE ASSEMBLY INSTRUCTIONS • Slip the base over both the columns and attach the base with the socket head Hex Socket Cap Screw (4) cap screw and the M8 allen wrench. M8 Allen Wrench • Attach the handle to the worksurface with the 1/2”...
  • Page 4 THE ANDERN MONO COLUMN TABLE ASSEMBLY INSTRUCTIONS • Twist in the glides or the (optional) castors into the Glides (4) holes on the bottom of the base. • If not secure OPTIONAL enough, tighten with Castors (4) 1/2” wrench. 1/2” Wrench...

Table of Contents