KYMCO K-XCT 300i Owner's Manual page 567

13. Electrical Systems
LIGHTS, SWITCHES, AND FUEL PUMP
GENERAL INSTRUCTIONS
• Note the following when replacing the halogen headlight bulb
1. Wear clean gloves while replacing the bulb. Do not put finger prints on
the headlight bulb, as they may create hot spots on the bulb and cause
it to fail.
2. If you touch the bulb with your bare hands, clean it with a cloth
moistened with alcohol to prevent its early failure.
3. Be sure to install the dust cover after replacing the bulb.
• Check the battery condition before performing any inspection that requires proper battery
voltage.
• A continuity test can be made with the switches installed on the scooter.
• Route the wires and cables properly after servicing each component.
TROUBLESHOOTING
Lights do not come on when ignition switch is "ON"
• Burned bulb
• Faulty switch
• Poorly connected, broken or shorted wire
Temperature gauge does not register correctly
• Faulty temperature gauge
• Faulty thermosensor
• Broken or shorted wire between the temperature gauge and thermosensor
Fuel gauge does not work or shows wrong figures
• Faulty fuel gauge
• Faulty fuel unit
• Poorly connected wire between fuel gauge and fuel unit
• Fuse burned out
13‐5
K- XCT 300i