Remove & Close The Lens Cover; Placing Your Projector - Magnavox MP601 Owner's Manual

Remove & Close The Lens Cover
Remove the lens
cover before using
REMOVE
LENS COVER
LENS COVER
OK
Fig. 1

Placing Your Projector

Your projector can be installed in four different configurations (see picture below):
Front Table
Rear Table
Front Ceiling
Rear Ceiling
Assemble the supplied
lens hood to the unit
as illustrated below:
CLOSE
LENS COVER
Fig. 2
OK
Front Table:
Select this location with the projector placed near
the floor in front of the screen. This is the most
common way to position the projector for quick
setup and portability.
Rear Table:
Select this location with the projector placed near
the floor behind the screen.
NOTE: A special rear projection screen is required.
Front Ceiling:
Select this location with the projector suspended
upside-down from the ceiling in front of the screen.
NOTE: A projector mount is required to install the
projector on a ceiling.
Rear Ceiling:
Select this location with the projector suspended
upside-down from the ceiling behind the screen.
NOTE: A projector mount is required to install the
projector in a ceiling.
A special rear projection screen is required.
When finished, remove
the lens hood from
the unit:
REMOVE
Fig. 3
OK
4
Close the lens cover
when unit not in use
CLOSE
LENS COVER
OK
Fig. 4