National Instruments 6509 Programmer's Manual page 48

Index
N
National Instruments support and
services, A-1
NI Measurement Hardware Driver
Development Kit (DDK), 3-1
programming your device without, 3-1
NI support and services, A-1
non-recurring registers
Automatic Clock Selection register, 2-19
Change Status register, 2-15
Clear register, 2-14
Filter Interval 32-Bit register, 2-18
ID register, 2-13
Master Interrupt Control register, 2-16
Revision register, 2-17
table, 2-2
Watchdog Timer Expire Status
register, 2-21
Watchdog Timer Software Timeout
Enable register, 2-20
Watchdog Timer Timeout Interval
register, 2-22
P
PCI bus
initializing, 3-2
example, 3-3
PCI Interface, 1-2
programming examples, 3-1
See also NI Measurement Hardware
Driver Development Kit (DDK)
programming examples (NI resources), A-1
Static DIO Register-Level Programmer Manual
R
recurring port registers
Falling Edge Sensitivity Configuration
registers, 2-7
Filter Enable registers, 2-8
IO Port Data, 2-4
IO Select registers, 2-5
Rising Edge Sensitivity Configuration
registers, 2-6
RTSI Enable registers, 2-12
Watchdog Timer Enable registers, 2-10
Watchdog Timer High or Low
registers, 2-11
Watchdog Timers High-Impedance
registers, 2-9
Recurring Port Registers (table), 2-2
REE(N) bits, Rising Edge Sensitivity
Configuration registers, 2-6
Rev(N) bits, Revision register, 2-17
RTSI configuration registers
RTSI Edge Detection Configuration
register, 2-27
RTSI Input Route register, 2-23
RTSI Pulse when Edge Detected
register, 2-24
RTSI Pulse when Watchdog Timer
Expires register, 2-25
RTSI Trigger for Watchdog Timer
register, 2-26
RTSI Configuration Registers (table), 2-3
RTSI Edge Detection Configuration register
Falling Edge Sensitivity bits, 2-27
Rising Edge Sensitivity bits, 2-27
Synchronous Edge Detect bits, 2-27
I-2 ni.com