Advertisement
Fig. 36: Identifying Ignition/Starter Switch Lock Cylinder Components
Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
Removing
1
Remove transponder coil and
put to one side with electrical
line connected
2
Remove clamp (2)
3
Insert transmitter key (3) into
the lock cylinder of the
ignition/starter switch (1) and
switch on ignition (circuit 15)
4
Slide in feeler gauge (4), on the
left side as shown, between the
lock cylinder of the
ignition/starter switch (1) and
electronic selector lever module
control unit (N15/5)
5
Pull out lock cylinder of
ignition/starter switch (1) with
transmitter key (3) upwards
Install
6
Insert lock cylinder of
ignition/starter switch (1) with
transmitter key (3) in the
electronic selector lever module
control unit (N15/5)
7
Remove transmitter key (3)
8
Install transponder coil
Ensure that the selector lever
is located in position "P".
Use blade of feeler gauge (4)
with the thickness of 0.15 mm.
If necessary move the feeler
gauge (4) slightly, so that the
locking device (5) is released
from the bracket (arrow).
Ensure that the selector lever
is located in position "P".
The lock cylinder of the
ignition/starter switch (1) must
engage audibly in the electronic
selector lever module (N15/5)
control unit.
AR80.35-P-
4515MCU
AR80.35-P-
Advertisement
