Hitachi WH 18DBSL Handling Instructions Manual page 33

(1) Removing the hook.
Remove the screws fi xing the hook with Philips screw
driver. (Fig. 8)
(2) Replacing the hook and tightening the screws.
Install securely the hook in the groove of power tool and
tighten the screws to fi x the hook fi rmly. (Fig. 9)
4. About Remaining Battery Indicator
Remaining battery power can be verifi ed by
pulling on the switch to light up the remaining
battery indicator lamp. (Fig. 10)
The indicator lamp will turn off 10 seconds after
the switch is released. The Table 4 shows the
state of remaining battery indicator lamp and
the battery remaining power.
State of lamp
As the remaining battery indicator shows somewhat diff erently depending on ambient
temperature and battery characteristics, read it as a reference.
Table 4
Battery Remaining Power
The battery remaining power is enough.
The battery remaining power is a half.
The battery remaining power is nearly empty.
Re-charge the battery soonest possible.
33
Hook
Hook
Display panel
Remaining battery
indicator lamp
Fig. 10
English
Groove
Screw
Fig. 8
Groove
Screw
Fig. 9
Switch
trigger