Related Manuals for Hitachi WH 13DBEL
Summary of Contents for Hitachi WH 13DBEL
- Page 1 Cordless Impact Driver WH 14DBEL WH 18DBEL • Handling instructions WH18DBEL Read through carefully and understand these instructions before use.
- Page 2 UC18YML2 UC18YML2 UC18YML2 UC18YRSL / UC18YML2 UC18YFSL UC18YGSL & BSL1440 BSL1840 BSL1430 BSL1830 BSL1820 UC18YRSL / UC18YML2 UC18YGSL...
- Page 4 Rechargeable battery Latch Battery cover Terminals Ventilation holes Push Pull out Handle Charger Pilot lamp Strap Connecting socket Charger connecting plug Cigarette lighter connecting plug Line Driver bit Movement & Guide sleeve Hexagonal hole in the anvil Trigger switch Selector button marks Screw Hook...
- Page 6 ○ ○ ○ ○...
- Page 7 ○ ○...
- Page 8 ○ ○ ○ ○ ○...
- Page 10 ○ ○ ○ ○ ○...
- Page 11 ○ ○ ○ ○ ○...
-
Page 13: General Safety Rules
d) Remove any adjusting key or wrench before GENERAL SAFETY RULES turning the power tool on. A wrench or a key left attached to a rotating part of the WARNING! power tool may result in personal injury. Read all instructions e) Do not overreach. -
Page 14: Caution On Lithium-Ion Battery
d) When battery pack is not in use, keep it away 15. Bring the battery to the shop from which it was purchased from other metal objects like paper clips, coins, as soon as the post-charging battery life becomes too keys, nails, screws, or other small metal objects short for practical use. -
Page 15: Specifications
2. If liquid leaks onto your skin or clothes, wash well with ○ Do not place electrically conductive cuttings, nails, clean water such as tap water immediately. steel wire, copper wire or other wire in the storage There is a possibility that this can cause skin irritation. case. - Page 16 ○ Insert the cigarette lighter connecting plug into the CHARGING cigarette lighter socket. If the plug is loose and falls out of the cigarette lighter Before using the power tool, charge the battery as follows. socket, repair the socket. As the socket may be faulty, 1.
- Page 17 5. Hold the charger fi rmly and pull out the battery. not cause the pilot lamp to blink in red (every second), NOTE please take the charger to the Hitachi Authorized Service Be sure to pull out the battery from the charger after use, Center.
-
Page 18: Prior To Operation
5. Tightening and loosening screws PRIOR TO OPERATION Install the bit that matches the screw, line up the bit in the grooves of the head of the screw, then tighten it. 1. Preparing and checking the work environment Push the impact driver just enough to keep the bit fi tting Make sure that the work site meets all the conditions laid the head of the screw. -
Page 19: Maintenance And Inspection
If the battery usage time is extremely short despite repeated charging and use, consider the batteries dead and purchase new batteries. 6. Service parts list CAUTION Repair, modifi cation and inspection of Hitachi Power Tools must be carried out by an Hitachi Authorized Service Center. - Page 24 Code No. C99209721 G Printed in China...