Using Drill Chuck, Chuck Adapter - Hitachi DH 45ME Handling Instructions Manual

7. Using Continuous operation button
The Continuous operation button feature is only
available for "Hammering Mode ". Pressing the
Continuous operation button will switch on a blue
LED that indicates the activation of the Continuous
operation function which will keep the tool running
even after the trigger switch is released. To cancel
the function, press the Continuous operation button
again or push the trigger switch to the ON position.
(Fig. 12)
NOTE
Continuous operation will be deactivated when the
switch is pressed. During continuous operation,
keep your hand away from the switch and grip the
lower part of the handle to avoid any unintentional
contact with the switch. (Fig. 13)
8. How to use the drill bit (taper shank) and the taper
shank adaptor.
(1) Install drill bit with taper shank in the taper shank
adaptor. (Fig. 14)
(2) Turn the power on and drill a base hole.
(3) After cleaning out dust with a syringe, attach the plug
to the anchor tip and drive in the anchor with plug to
the anchor tip and drive in the anchor with a manual
hammer.
(4) To remove the drill bit with taper shank, insert a cotter
into the slot of the taper shank adaptor, place supports
under the Rotary Hammer and tap the cotter with a
manual hammer. (Fig. 15)

USING DRILL CHUCK, CHUCK ADAPTER

Note that this machine can be used at "rotation only" if separately sold parts such as drill
chuck and chuck adapter are attached. Use it with the selector lever positioned at "rotation +
hammering".
Taper shank adaptor
Drill bit
(Taper shank)
31
English
Switch
Continuous
operation
button
LED (Blue)
Fig. 12
Fig. 13
Fig. 14
Taper shank
adaptor
Cotter
Support
Fig. 15