Frequently Asked Questions; Charging; Calls; Caller Line Identification (Cli) Service Does Not Work - Philips SE4451S/05 User Manual

14

Frequently asked questions

www.philips.com/support

Charging

The icon is not blinking when the
f
handset is placed on the base
• Bad battery contact – move the handset
slightly
• Dirty contact – Clean the battery contact
with a cloth moistened with alcohol
• Battery is full – no need to charge

Calls

No dialling tone
• No power – check the connections. Reset the
phone: unplug and plug back in the mains
• Batteries are empty – charge the batteries for
at least 24 hours
• You are too far from the base – move closer
to the base
• Wrong line cable – use the line cable provided
• Line adaptor (when needed) is not connected
to the line cord – connect the line adaptor
(when needed) to the line cord
Poor audio quality
The base is too close to electrical appliances,
reinforced concrete walls or metal doorframes
– move the base at least one metre away from
any electrical appliances
N
The icon is blinking
• Handset is not registered to the base
– register the handset to the base
• You are too far from the base – move closer
to the base
No ring tone
The ring tone is deactivated.
Increase the volume.
Frequently asked questions
Caller Line Identification (CLI) service
does not work
Check your subscription with your network
operator

Phonebook

A phonebook entry cannot be stored
The phonebook is full. Delete an entry to free
memory

Display

No display
• Try recharging or replacing the batteries.
• Try disconnecting and connecting the base
power supply.
• If 7 segment display is not lit up, then try
disconnecting and connecting the base
power supply.

Registration

Unable to register another handset
Maximum number of 5 handsets has been
reached.
The display shows SEARCHING. You must
unregister a handset in order to register a new
one.

Interference

Noise interference on your radio or
television
Your base or charger may be too close. Move it
as far away as possible.
33