Brew Group - Saeco 10003024 Operating Instructions Manual

• Do not wash any of its parts in the
dishwasher.
• Do not use sharp objects or harsh che-
mical products (solvents) for cleaning.
• Use a soft, dampened cloth to clean the
machine.
• Do not dry the machine and/or its
components using a microwave and/
or standard oven.
After brewing milk beverages,
dispense hot water from the
steam wand (Pannarello, if supplied)
to obtain a thorough cleaning.
• Every day, after heating the milk, remo-
ve the external part of the Pannarello
(if supplied) and wash it with fresh
drinking water.
• Clean the steam wand weekly. In order
to do this, perform the following ope-
rations:
- Remove the external part of the
Pannarello (for standard cleaning);
- Remove the upper part of the Panna-
rello from the steam wand;
- Wash the upper part of the Pannarel-
lo with fresh drinking water;
- Wash the steam wand with a wet
cloth and remove any milk residue;
- Replace the upper part in the steam
wand (make sure it is completely
inserted).
Reassemble the external part of the
Pannarello.
• It is recommended to clean the water
tank daily:
- Remove the small white fi lter from
the water tank and wash it under
running drinking water.
- Reposition the small white fi lter in
its housing by gently pressing and
turning it at the same time.
- Fill the water tank with fresh drinking
water.
• Empty and clean the drip tray daily.
Perform this operation also when the
fl oat is raised.
• 24 •

Brew Group

• The brew group should be cleaned
every time the coff ee bean hopper is
fi lled or at least once a week.
• Turn off the machine by pressing the
ON/OFF button and remove the plug
from the socket.
• Remove the coffee grounds drawer.
Open the service door.
• To remove the brew group, pull it by the
handle and press the «PUSH» button.
The brew group must be washed only
with lukewarm water with no deter-
gent/soap.
• Wash the brew group with lukewarm
water and carefully clean the upper
fi lter.
• Thoroughly wash and dry all the parts
of the brew group.
• Thoroughly clean the inside of the
machine.
• Make sure that the two reference signs
match up.
• Make sure that the lever is in contact
with the brew group. Press the "PUSH"
button to make sure that the brew
group is in the correct position.
Lubricate the brew group
after approximately 500
brewing cycles. The grease to lubrica-
te the brew group may be purchased
at authorised service centres.
• Lubricate the brew group guides using
the supplied grease only.
• Apply the grease evenly on both side
guides.
• Insert the brew group in its seat until it
locks into place WITHOUT pressing the
"PUSH" button.
• Insert the coff ee grounds drawer. Close
the service door.