Connections - JVC TD-V661 Instructions Manual

CONNECTIONS
1. Connection to a stereo amplifier
• Do not switch the power on until all the connections are
completed.
• Insert the plugs firmly, or poor contact will result, causing
noise.
• When the pin-plug cords are employed, always connect the
white plug to the left channel terminal. This helps to avoid
reversed connections.
• When using the Compu Link Control System version 3, do
not connect the power cord to the SWITCHED AC OUTLET
of an amplifier or receiver. Otherwise, the automatic power
on/off (STANDBY) function cannot be carried out.
When Installing the deck, be sure to Install at a distance from
your amplifier. If they are stacked, noise (hum) may occur.
2. Remote cable connection for COMPU LINK
• By connecting a remote cable, COMPU LINK functions (auto
matic power on/off (STANDBY), automatic source selec
tion, synchronized recording and DDRP recording) can be
performed. In this time the provided pin-plug cords must be
also connected.
• When making synchronized recording with a CD player,
connect the remote cable.to the COMPU LINK-1/SYNCHR0
or COMPU LINK-3/SYNCHR0 jacks.
Notes:
1. When making synchronized recordings, only a single deck
should be connected to the amplifier.
2. If a component Is not a JVC COMPU LINK component,
bypass It when making the remote cable connections.
3. This deck can be connected with an amplifier and a CD
player which have the COMPU LINK-I/SYNCHRO jacks for
COMPU LINK performance.(see page 10 for detail)
Pin-plug cords (provided)
Pin-plug cords (optional)
ll# ff
1 «l I ® J «■ I
M(<§ BISHT
Stereo amplifier
Remote cable (provided)
^OUT PUT—s
FIXED VARIABLE
CD player
Remote cable (provided with CD player)
' When making DDRP recording connect pin-plug cords with the terminals "VARIABLE".