Instruction manual for radio cassette receiver (70 pages)
Summary of Contents for JVC TD-W254
DOLBY B NR REVERSE MODE OFF C AUTO TAPE SELECTOR / CONTINUOUS PLAY STANDBY / ON (B version) INSTRUCTIONS DOLBY B-C NR HX PRO TD-W254 DOUBLE CASSETTE DECK AUTO REVERSE 3MOTOR SILENT MECHANISM REC/PLAYBACK PLAYBACK PLAY COMPULINK Component A B SYNCHRO DUBBING...
RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION ‘‘TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER (OR BACK) NO USER SERVICEABLE PARTS INSIDE REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.’’ The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated ‘‘dangerous voltage’’...
INTRODUCTION Thank you for purchasing a JVC product. Read this instruction book carefully before operating to be sure of getting optimum performance and longer service life from the unit. CONTENTS Features ... 3 Cautions ... 3 Connections ... 5 Cassette loading ... 5 Names of parts and their functions ...
2. Installation 1) Avoid placing the unit on or adjacent to an amplifier, to pre- vent hum from being produced by some types of amplifiers. Move the unit to a place not affected by the amplifier. Keep the unit as far as possible from a TV set. 2) Avoid installing the unit in a location subject to ambient tem- peratures exceeding 40 °C (104 °F) (e.g.
1. When making synchronized recordings, only a single deck should be connected to the amplifier. 2. If a component is not a JVC COMPU LINK component, bypass it when making the remote cable connections. 3. This deck can be connected with an amplifier and a CD player which have the COMPU LINK-1/SYNCHRO jacks for COMPU LINK performance.
NAMES OF PARTS AND THEIR FUNCTIONS TD-W254 DOUBLE CASSETTE DECK TD-W254 DOUBLE CASSETTE DECK AUTO REVERSE 3MOTOR SILENT MECHANISM PLAYBACK PLAYBACK COMPULINK COMPULINK Component Component POWER POWER REVERSE MODE DOLBY B NR OFF C STANDBY / ON (B version) (J version)
t INPUT LEVEL control y Cassette operation buttons (deck B) : Press to wind the tape quickly from right to left. : Press to wind the tape quickly from left to right. (stop) : Press to stop the tape. Also press to stop both decks simulta- neously during dubbing.
POWER DDRP (Dynamics Detection Recording Processor) record- (J version) DDRP recording is performed with suitable JVC CD players and the recording level adjustment is performed automatically. Since recording level adjustment is performed automatically for different types of tape (normal, CrO of INPUT LEVEL control is not required.
PAUSE button to enter the This is a system originated and developed by JVC for facilitating various system operations. There are two versions of this sys- tem; version 1 and 3. (For version 1 components, ‘‘COMPU LINK-1/SYNCHRO’’...
DDRP (Dynamics Detection Recording Processor) record- The DDRP function makes possible fully automatic recording when used with a suitable JVC CD player. When the DDRP but- ton of a suitable JVC CD player is pressed, the recording level is first adjusted automatically, then recording starts; it is not nec- essary to start recording by the normal procedure.
Tape editing 1. Press the REC/REC MUTE button when finished dubbing a tune. Deck B automatically enters the record muting mode and leaves a non-recorded section of about 4-seconds then enters the record-paused mode. 2. Press the (stop) button of deck A and search for the next tune you want by using the stop the cassette just before the beginning of the tune.