PLAYBACK
DOLBY NR
^ONJiGFF
aCAB
Operate in the order of the numbers in the illustration.
O Press the POWER switch to set to ON .
0 Load a prerecorded cassette.
0 Press the same DOLBY NR switches that were pressed when
the tape was recorded.
O Press the ► (play) button to start playback.
• When the deck contains a tape, the deck is turned on auto
matically and the tape is played back by only pressing the ►
(play) button.
• It changes to the tape monitor mode automatically and 'TAPE"
will appear on the display.
• To stop playing back midway
Press ■ (stop) button.
Tape counter display
When the power is turned on, the counter value which the
POWER switch was set to STANDBY, appears on the display.
When the tape runs, the counter functions as a 4 digit linear tape
counter. The running time is displayed in minutes and seconds
(countdown function included). Since the counter is not a clock,
there may be a discrepancy between the actual recording and
playback times. This discrepancy will vary depending on the
length of the tape and the hub diameter.
To set the counter to "0.00".
Press the RESET button.
MEMORY BUTTON
Memory function operates at the point where the tape counter is
"0.00". Press the RESET button to set the counter to "0.00" at the
point to which you want the tape to be rewound and from which
you want to listen to during recording or playback.
The tape stops automatically at the point where the counter is
"0.00" in either the fast forward or rewind mode.
• The point where the counter is "0.00" is stored during any
mode (recording, playback or stop), but the memory function
(automatic stop) operates only in the fast forward or rewind
mode.
• If pressing the MEMORY button again, the memory will be
cleared. It will also be cleared if pressed the RESET button
and reset the counter to "0.00".