Makita HM1205C Technical Information page 17

W
iring diagram
Fig. D-3
Connect the insulated connectors so that
the clamped portions are set inside the
width of Switch as shown below.
The clamped
portions
Fig. D-4
The following Lead wires have to be
routed over Lead wire (thin, black)
and to be routed through Lead wire holder.
* Lead wire (thick, black) connected to
Switch and Terminal block
* Lead wire (thick, white) connected to
Switch and Controller
Connector
for connecting
to Controller
Wiring to Switch
Switch
the width of
Switch
Terminal block
If the clamped portions of insulated connectors
are out of the width of Switch, they interfere with
installing Switch.
The clamped
portions
Wiring in Handle
Insulated connectors
Lead wires must be tightened
in this position.
Lead wire holder
covered with Sponge
sheet
Lead wire holder
Switch
the width of
Switch
Switch
Fix Lead wires with
Sponge sheet and
Lead wire holder.
Route Lead wires through
these lead wire holders.
P 17/ 17