Saunders Lumbar Traction User Manual page 11

Storage
Your Saunders Lumbar Traction device should be stored in its
protective case. Replace the pump in the mesh storage compartment
on the inside of the carrying case. Fold all harnesses, closing buckles
where applicable. Fully zip the carrying case.
Troubleshooting
The Saunders Lumbar Traction device features a very accurate,
sensitive gauge. The pump is specifically designed not to leak in the
"HOLD" position. If you notice a drop in the gauge reading when in the
"HOLD" position, it is probably because you have relaxed or moved
slightly. If this happens, return to the "PUMP" position and pump back
to the desired force, then reset to "HOLD."
Proper operation of the Saunders Lumbar Traction device requires
that the air system be virtually leak-free. If the traction force is not
maintained, there may be a leak somewhere in the system.
Questions to Ask:
• Is the pump in the "PUMP" position when pumping?
• Is the pump in the "HOLD" position when receiving treatment?
• Are you lying still? (Any movement will cause fluctuation.)
• Are you pumping slowly?
• Are all connections tight? (i.e. pump hose cap and gauge lens cap)
If the unit is leaking air, try the following:
• Check the air hose and connections at the hand pump for leaks.
• Gently tighten as necessary. Do not over-tighten as the threads
may strip.
• Perform a POP test. With no one in the device, PUMP up the
pressure until you hear a "pop" noise (at about 200 lbs.) Then
rotate the gauge to the RELEASE position and proceed with your
treatment.
If you have any questions, please call your authorized Empi Traction
Dealer or call Empi Customer Service at 1-800-862-2342.
English
9 / 184