Infinity Beta SW Series Service Manual page 6

CSW-10
C
ONNECTIONS
If you have a Dolby* Digital or DTS
with a low-frequency-effects (LFE) output:
SUBWOOFER OR
LFE OUTPUT
• Set Normal/LFE Switch to LFE.
NOTE: In this case, you do not need to use a Y connector. Simply
connect the LFE output on your receiver/processor to either the
left or right input on the subwoofer.
CSW-10
® receiver/processor
5
If your receiver/processor has subwoofer
outputs for the left and right channels:
• Set Normal/LFE Switch to Normal.
NOTE: Some receivers have a single subwoofer output (do not confuse
this with a single LFE output as described to the left). In that case, it is
recommended that you use a Y connector (not included) to maximize
performance.