Oven Lamp And Lamp Socket Removal; Positive Lock® Connector (No-Case Type) Removal; Turntable Motor Removal - Electrolux FGMO205KFA Service Manual

Section 4 Component Teardown

Oven Lamp And Lamp Socket Removal

1. Disconnect the power supply cord and remove outer
case.
2. Open the door and block it open.
3. Discharge high voltage capacitor.
NOTE
To discharge the high voltage capacitor, wait for 60
seconds and then short-circuit the connection of the
high-voltage capacitor (that is the connecting lead of
the high-voltage rectifier) against the chassis with the
use of an insulated screwdriver.
4. Remove the oven lamp from the oven lamp socket.
5. Pull the wire leads from the oven lamp socket by
pushing the terminal hole of the oven lamp socket
with the small flat type screw driver.
6. Remove the oven lamp socket from the magnetron
duct by turning the socket counterclockwise.
7. Remove the oven lamp from the socket by turning
the oven lamp.
8. Now, the oven lamp and the oven lamp socket are
free.
Figure 4-2. Oven Lamp Socket
4-4
Positive Lock® Connector (No-Case Type)
Removal
1. Push the lever of positive lock
2. Pull down on the positive lock
Figure 4-3. Positive Lock
CAUTION
When connecting the positive lock
to the terminals, connect the positive lock
that the lever faces you.

Turntable Motor Removal

1. Disconnect the power supply cord.
2. Remove turntable and turntable support from oven
cavity.
3. Lay the oven on its' backside. Remove the turntable
motor cover by snipping off the material in four
corners.
4. Where the corners have been snipped off bend
corner areas flat. No sharp edges must be evident
after removal of the turntable motor cover.
5. Disconnect wire leads from turntable motor.
(See "Positive lock connector removal")
6. Remove one (1) screw holding turntable motor to
oven cavity.
7. Now the turntable motor is free.
8. After replacement, use the one (1) screw provided
with the turntable motor, to attach the turntable
motor cover.
connector.
®
®
connector.
Connector
®
®
connectors
®
so