Sealer Film - Electrolux FGMO205KFA Service Manual

Section 4 Component Teardown
Figure 4-8. Door Components
Note: When carrying out any repair to the door,
do not bend or wrap the slit choke (tabs on the
door panel assembly) to prevent microwave
leakage.
Reinstall
1. Re-install door screen to door frame.
2. Re-install the latch spring to the latch head.
Re-install the latch spring to the door frame.
Re-install latch head to door frame.
3. Re-install door panel to door frame by fitting twelve
(12) tabs of door frame to twelve (12) holes of door
panel.
4. Put sealer film on door panel. Refer to "Sealer Film"
about how to handle new one.
5. Catch two (2) pins of door panel on two (2) hole of
upper and lower oven hinges.
6. Re-install choke cover to door panel by pushing.
NOTE
After any service to the door:
1. Make sure that door sensing switch and secondary
interlock switch are operating properly. (Refer to
section 3 "Test Procedures".).
2. An approved microwave survey meter should be
used to assure compliance with proper microwave
radiation emission limitation standards.
4-10
After any servicing, make sure of the following:
1. Door latch heads smoothly catch latch hook through
latch holes and that latch head goes through center
of latch hole.
2. Deviation of door alignment from horizontal line of
cavity face plate is to be less than 1.0mm.
3. Door is positioned with its face pressed toward
cavity face plate.
4. Re-install outer case and check for microwave
leakage around door with an approved microwave
survey meter. (Refer to Microwave Measurement
Procedure.)
NOTE
The door on a microwave oven is designed to act as an
electronic seal preventing leakage of microwave energy
from oven cavity during cook cycle. This function
does not require that door be air-tight, moisture-tight
or light-tight. Therefore, occasional appearance of
moisture, light or sensing of gentle warm air movement
around oven door is not abnormal and does not
indicate a leakage of microwave energy from oven
cavity.

Sealer Film

Installation
1. Put the adhesive tape on the backing film of the
sealer film as shown in Figure 4-9.
2. Tear the backing film by pulling the adhesive tape.
3. Put the pasted side of the sealer film on the door
panel.
Figure 4-9. Door Components