Oven Lamp And Lamp Socket Removal; (No-Case Type) Removal; Fan Motor Removal - Electrolux E30MO65GSSB Technical & Service Manual

HEATING ELEMENT REMOVAL
1. Remove two (2) screws holding heating element to
heater duct.
2. Loosen two (2) screws holding holders to heater duct
and take heating element out of heating element
holders. Heating element is free.
After completely installing the heating element,
bend the top of the heating element holder to
inside using by long nose pliers as shown in the
following illustration.
Figure 4-2. Heating Element Removal
Oven Lamp And Lamp Socket
Removal
1. Disconnect oven from power supply and remove
outer case.
2. Discharge high voltage capacitor.
To discharge the high voltage capacitor, wait for 60
seconds and then short-circuit the connection of
the high-voltage capacitor (that is the connecting
lead of the high-voltage rectifier) against the
chassis with the use of an insulated screwdriver.
3. Bend the tab of the air guide holding the lamp socket.
4. Lift up the oven lamp socket.
5. Pull the wire leads from the oven lamp socket by
pushing the terminal hole of the oven lamp socket
with the small flat type screw driver. The oven lamp
socket is free.
Component Teardown
Figure 4-3. Oven Lamp Socket Removal

Fan Motor Removal

Removal
1. Disconnect the oven power supply cord and remove
outer case.
2. Discharge high voltage capacitor.
To discharge the high voltage capacitor, wait for 60
seconds and then short-circuit the connection of
the high-voltage capacitor (that is the connecting
lead of the high-voltage rectifier) against the
chassis with the use of an insulated screwdriver.
3. Disconnect the wire leads from the fan motor.
4. Remove one (1) screw holding the fan motor
grounding wire to the air guide (Right).
5. Remove three (3) screws holding the chassis support
to the rear cabinet, waveguide and control panel back
plate.
6. Remove the chassis support from the oven.
7. Remove one (1) screw holding the magnetron air
guide to the waveguide.
8. Remove the magnetron air guide from the waveguide.
9. Disconnect wire leads from the fan motor.
10. Release the main harness from the hole of the fan
duct.
11. Release the thermistor harness from the hole of the
fan duct.
12. Release one (1) tab holding the fan duct to the rear
cabinet.
13. Release one (1) tab holding the fan duct to the air
guide (Right).
14. Remove the fan duct assembly from the oven.
4-5