JRC JSS-2150 Instruction Manual page 79

(2) Setting the ITU channels
■ ■
Procedure
1 1 . .
1 .
After setting the TEL, DSC or CW modes,
press the CH key to set the display to the
ITU channel mode.
2 2 . .
2 .
Input the channel by using the numeric
keypad.
When 4 is input using the numeric
Note
keypad, it appears on the far right
as shown in the screen on the right.
3 3 . .
3 .
Input the rest of the digits and press ENT.
The input ITU channel frequency is displayed
and the settings are complete.
- See the appendix "11.4 ITU channel list (TEL/CW/TLX)" for a list of
Note
pre-installed ITU channels and their frequencies.
Besides doing settings with the numeric keypad, settings can also be done with
-
the jog dial.
- For DSC mode, normally perform the above procedure to receive the routine
message. Furthermore, when sending a DSC message, the calling frequency is
set via the menu automatically and the above procedure is not needed.
- The above operation is unavailable in the telex mode. The ITU channel in the
telex mode is set with the controller menu 5.2 ITU channel list, or the data
terminal menu operation, as Tune ITU channel set.
Operation
4-27