Table of Contents
Advertisement
This connection allows you to program an unattended recording of more than one unscram-
bled channel and to watch one channel while recording another. After you connect the VCR,
Cable Box, and TV as shown below, the features on this page will be available.
1. Connect a Cable
signal to the VCR's
ANT(enna) IN Jack.
Recording One Channel/Watching Another
1
With the VCR in VCR position (the VCR light will appear on the dis-
play panel), use the CHANNEL (Up/Down) buttons to select
the channel you want to record. Start the recording.
2
Press the VCR/TV button once to put the VCR in TV
position.
3
Use the TV channel selector to put the TV on the Cable Box
output channel (channel 3 or 4).
4
Select the channel you want to watch at the Cable Box.
Playing a Tape
1
Press the VCR/TV button to put the VCR in VCR position
(the VCR light will appear on the display panel).
2
Make sure the Cable Box is on the same channel as the
VCR's CH3/CH4 switch.
3
Use the TV channel selector to put the TV on the Cable Box
output channel (channel 3 or 4).
4
Press the PLAY button to play the tape.
Hookups With a Cable Box (cont'd) 9
2. Use an RF coaxial cable (supplied) to connect
the OUT Jack on the VCR to the IN Jack on
the Cable Box.
ANT
AUDIO
IN
L
OUT
IN
R
OUT
VIDEO
CH3
CH4
OUT
IN
3. Use a second RF coaxial cable to connect the OUT Jack on
the Cable Box to the ANTENNA IN Jack on the back of the TV.
IN
OU T
• You cannot record scrambled chan-
nels with this connection.
7 5
A N T
/
C A B
L E
TV ANTENNA IN Jack
Helpful Hint
Advertisement
Table of Contents
