Operating Instructions; During Operation Safety; After Operation; Transporting - Exmark STANDON Series Operator's Manual

5. For operation of StandOn with Viking Hydro,
Turf Tracer S-Series, and Turf Tracer HP on hilly
terrain, front weight kit accessory, P/N 103-2637,
is recommended.
6. For operators over 250 lb (113 kg), it is
recommended to use pneumatic tire assembly,
P/N 103-3798.

Operating Instructions

During Operation Safety

General Safety
The operator must use their full attention when
operating the machine. Do Not engage in any activity
that causes distractions; otherwise, injury or property
damage may occur.
• The StandOn was designed for one operator only.
Do not carry passengers and keep all others away
from machine during operation.
• Operate only in daylight or good artificial light.
• Keep away from holes, ruts, bumps, rocks, and
other hidden hazards. Use care when approaching
blind corners, shrubs, trees, tall grass or other
objects that may hide obstacles or obscure vision.
Uneven terrain could overturn the machine or
cause the operator to lose their balance or footing.
Operating
DANGER
If the StandOn rotates beyond 90°, there is
a potential crushing hazard. Rapid rotation
beyond 90° can cause the StandOn to jackknife
into the mower engine deck and cause serious
injury.
• Dismount the StandOn and place in transport
position before operating in reverse.
• Reduce speed when making sharp turns and
operating on slopes.
1. Use care when turning to ensure that you Do Not
swing yourself and the sulky into obstacles.
2. When turning, lean forward and toward the
direction of the turn to help in keeping balance.

After Operation

General Safety
• Park machine on level ground, disengage drives,
set parking brake, stop engine, remove key or
disconnect spark plug wire. Wait for all movement
to stop and allow the machine to cool before
adjusting, cleaning, repairing, or storing. Never
allow untrained personnel to service machine.
• Clean the machine as stated in the Maintenance
section.
• Frequently check for worn or deteriorating
components that could create a hazard. Tighten
loose hardware.

Transporting

Transporting the StandOn
Use the platform side handles to lift and rotate the
StandOn into transport position when loading a
machine on a trailer, unloading a machine from a
trailer, or operating in reverse.
Important: Do Not use the drawbar to lift the
StandOn.
CAUTION
Fingers may be pinched when lifting and rotating
the platform.
Always use platform side handles to lift and
rotate the StandOn.
• Placing into Transport Position:
1. Using one of the platform side handles,
slightly lift the StandOn.
11
Operation