Operating Instructions - Exmark ARS180KA21 Operator's Manual

Operation
Refer to the Maintenance section and perform all the
necessary inspection and maintenance steps.

Operating Instructions

Handle Adjustment
The height of the handle can be adjusted for
comfortable operation. Stand behind the handle to
determine the height.
1. To adjust the handle height, position the hardware
into one of three sets of holes on each side of the
mainframe.
2. Refer to figures below for the different handle
positions. Two bolts must be used in the lift link
straps at all times.
Figure 6
Front Handle Position — Lowest Height
1. Trunnion
bracket–bottom hole
2. Lift link straps
3. Mounting bolt location
4. Handle hardware–front
holes
Middle Handle Position
1. Trunnion
bracket–bottom hole
2. Lift link straps
Rear Handle Position — Highest Height
1. Trunnion bracket–top
hole
2. Lift link straps
3. Adjust the tine ground engagement lever as stated
in the Adjustments section.
Open the Fuel Shut-Off Valve
Rotate the valve and align with the fuel line to open.
Starting the Engine
1. Connect the wire to the spark plug.
16
Figure 7
3. Mounting bolt location
4. Handle
hardware–middle holes
Figure 8
3. Mounting bolt location
4. Handle hardware–rear
holes