MC350E
Adjusting Height of the Needle Stop Position
The standard height of needle stop position should be 14.2 mm above the needle plate
surface when the machine is topped.
B
(B)
(A)
Needle #11
C
A
D
13
1. Remove the front cover unit. (See page 6)
2. Turn the power switch "ON" and press Start / Stop
button twice.
Stop the machine with the needle in the up position.
3. (A) If the needle stops higher than 14.2 mm
loosen Screw
A
shield plate
B
(B) If the needle stops lower than 14.2 mm
loosen Screw
A
shield plate
B
4. Place the right side of the Upper shaft shield plate
in the center of the slit of the Upper shaft sensor
and tighten Setcrew
5. Press the Start/Stop button twice to check the height
of the needle stop position.
6. Attach the front cover.
A
Screw
B
Upper shaft shield plate
C
Needle height (14.2 mm)
D
Upper shaft sensor
and turn the Upper shaft
in the direction of (A).
and turn the Upper shaft
in the direction of (B).
.
A
,
C
C
,
D