Table of Contents
Advertisement
MC350E
A
D
E
Changing External Parts (5) Base
A
C
B
A
Base
To remove:
1. Remove the Belt cover. (See page 2)
2. Remove Setscrew
the base unit .
3. Remove the X-Motor Connector
Connector
C
from the printed circuit board "A".
A
Setscrew
B
Joint bosses
C
Y-motor connector (White)
X-motor connector (Blue)
D
Extension table (Accessory)
E
To attach:
4. Attach the X, Y-Motor Connectors
the printed circuit board "A".
5. Insert the X, Y-Motor Cords between the printed
cuircuit board "A" and Arm. Be sure the cords
are not caught between the Joint Bosses
the arm and base. Tighten Screws
temporarily.
6. Attach the Extension (Accessory) table
A
7. Tighten Screws
table, base unit and free Arm.
Note: Attach the embroidery hoop with the template
on the carriage. Check the needle drop postion
against the template.
8. Attach the belt cover.
5
A
(4 pcs.), and remove
D
and Y-Motor
,
D
into
C
B
A
(4 pieces)
E
.
while aligning the extension
of
Hide quick links:
Advertisement
Table of Contents
