Table of Contents
Advertisement
OPERATION
OPERATION
PART OUTPUT button/knobs
This section contains further functions for PART editing. To access, press the [PART OUTPUT] button, as shown in
the following example:
Press to access
PART OUTPUT
The indicator below the [PART OUTPUT] button will flash to indicate this mode is active.
CAUTION!: as these controls are shared with the ENVELOPE section care must be taken to check the status of the
PART OUTPUT indicator before attempting to make any changes to the associated parameters.
LEVEL
This control sets the relative output LEVEL for the selected PART. At the fully anti-clockwise position there will be
no sound. As the control is moved in a clockwise direction the level will be gradually increased until, at the fully
clockwise position, the output level will be at its maximum. The main display will show the volume level setting from
0 to 127(max) when this control is moved.
PANNING
This control sets the amount of PANNING effect for the selected PART. At the 12 o'clock position there will be no
panning effect. As the knob is moved in an anti-clockwise direction the panning effect will be applied more and
more, with initial emphasis to the LEFT channel. As the knob is moved in a clockwise direction from the centre
position the panning effect will be applied more and more, with initial emphasis to the RIGHT channel.
The source for modulating the panning effect can be changed using a MENU function. To access the PANNING
OUTPUT settings, press the MENU button labelled [OUTPUT], as shown in the following example:
VALUE
MENU
UP
MENU
DOWN
VALUE
EDIT
The indicator in the [OUTPUT] button will light and the main display will now alternate between the first function and
its current value, as shown below:
Function =
Panning source
The selections are:
Pot -
The PANNING knob will affect the pan position directly. Anti-clockwise = Left, clockwise = Right.
Envelope1 -
The settings of envelope 1 controls will affect the pan position.
Envelope 2 -
The settings of envelope 2 controls will affect the pan position.
LFO1 -
The settings of the LFO1 controls will affect the pan position.
LFO2 -
The settings of the LFO2 controls will affect the pan position.
DarkStar Synthesizer
LEVEL
Min
Max
ATTACK
0
PART
OUTPUT
OSCILLATORS
FILTER
OUTPUT
BANK
PROG
PARAMETER
VALUE
PANNING
TREMOLO
Off
Off
-
-
+
+
Min
Max
Min
Max
Min
DECAY
SUSTAIN
1
2
3
4
5
6
7
VELOCITY LEVEL
Envelopes
Envelope 1
Envelope 2
LFO
PART
MENU
Display alternates
between
22
PORTAMENTO
Max
RELEASE
(VELOCITY)
(SHIFT)
PORTA/TRIGGER
MIDI
BANK
PROG
Setting = Envelope 1
PARAMETER
VALUE
MODULATION
Advertisement
Table of Contents
