Sdv30R - Vermont Castings 2767/FK26 Installation Instructions Manual

SDV30R

1. Remove the rear skirt insert panel at the bottom of the
rear skirt (Figure 47) and fasten the blower assembly to
the firebox back with the two (2) phillips pan head bolts
originally installed in the firebox back. ('A', Figure 48)
NOTE: Steps 2 and 3 do not apply when the RF valve is
used. After attaching the blower assembly to the firebox, run
the spliced female leads to the front of the stove and attach
to back of RF valve. (Figure 46)
2. Attach the snapstat assembly to the snapstat bracket
with two (2) sheet metal screws. ('B', Figure 48) Attach
the snapstat bracket to the stove with a hex head bolt
passing though the bracket and into the stove base. ('C',
Figure 48)
Pilot Assembly
Red
White
Red
White
Antenna
Figure 46 - FK26 is wired to back of Comfort Valve.
Rear Skirt
Sheet Metal
Screws
Rear
Skirt Insert
Figure 47 - Remove rear skirt insert.
15
Blower
White Dots
Valve
(Bottom View)
FP1038
comfort valve
wiring diagram
3/24/00 djt
ST313
fk26
install fan kit
rear skirt insert
1/24/00
Star Washer
Sheet Metal
Screws
Phillips
B
Pan Head
Bolts
A
Star
Washer
Figure 48 - Attach the fan assembly and the snapstat.
3. The rheostat control switch attaches to the left side of the
valve bracket at the front of the stove. (Figure 49)
•
Remove retaining nut from shaft of rheostat. (if
ST314
preinstalled)
Fk26ce
•
Insert the rheostat through the hole in the back of the
attach fan
left side of the valve bracket, aligning the locator pin
1/24/00
with the smaller hole in that bracket.
•
Thread the retaining nut onto the shaft of the rheostat,
tightening with a wrench. Do not overtighten.
•
Attach the control knob to the rheostat shaft.
•
Use the wire tie to secure the fan and rheostat wire
harnesses together.
Rheostat
Retaining nut
Rheostat Knob
Figure 49 - Attach fan rheostat.
Snapstat
1/4"-20
Hex Bolt
C
Snapstat
Bracket
Rheostat
Wire to Front
Rheostat
ST347a
JUV
FK28
rheostat install
9/21/00
2003135