Stardance Direct Vent Sddvt - Vermont Castings 2767/FK26 Installation Instructions Manual

Stardance Direct Vent - SDDVT
1. Remove the rear skirt insert panel at the bottom of the
Rear Skirt (Figure 15) and fasten the blower assembly
to the firebox back with the two Phillips pan-head bolts
originally installed in the firebox back. ('A', Figure 41)
Rear Skirt
Sheet Metal
Screws
Rear Skirt
Panel
Figure 40 - Remove rear skirt panel.
2. Attach the snapstat assembly to the snapstat bracket
with two sheet-metal screws. ('B', Figure 41) Attach
the snapstat bracket to the stove with a hex-head bolt
passing through the bracket and into the stove base.
('C', Figure 41)
3. The rheostat control switch attaches to the left side of the
valve bracket at the front of the stove. (Figure 42)
•
Remove retaining nut from shaft of rheostat. (if
preinstalled)
•
Insert the rheostat through the hole in the back of the
left side of the valve bracket, aligning the locator pin
with the smaller hole in that bracket.
•
Thread the retaining nut onto the shaft of the rheostat,
tightening with a wrench. Do not overtighten.
•
Attach the control knob to the rheostat shaft.
•
Use the wire tie to secure the fan and rheostat wire
harnesses together.
Sheet Metal
Screws
Phillips 1/4-
20 Bolts
A
Star
Washer
Rheostat
Assembly
Figure 41 - Attach fan assembly and snapstat.
ST314
13
Fk26ce
ST313
fk26
install fan kit
rear skirt insert
1/24/00
B
Snapstat
Snapstat
Bracket
C
1/4-20
Hex Bolt
Retaining Nut
Control Knob
Figure 42 - Attach rheostat to left side of valve.
Rheostat
Control
ST347a
JUV
FK28
rheostat install
9/21/00
2003135