Downloading Software To The Unidrives Using Winflasher 3; Figure 19 Unidrive Port - HP Indigo Press WS4000 Service Manual

HP Indigo press ws4000 Cluster 1 procedures

Downloading software to the Unidrives using WinFlasher 3

The following procedure for downloading software must be performed on each
Unidrive. Each Unidrive is loaded with its own unique software.
Warning: The download process causes the UD75 card to temporarily stop functioning,
causing damage to the press. Therefore, before downloading, press the
Emergency Stop button.
Press apart
to remove
cover
UniPorts.c dr
Pre-requisites
Unidrive Firmware Operating system file version 2.8 of higher
If the WHS software is lower than version 1.03, go to Downloading system files to the
Unidrive, on page 203 and follow the procedure there to download the software.
Procedure
•1. Check Unidrive parameter 17.2. If the value of this parameter is lower than
2.8, refer to Downloading system files to the Unidrive on page 203, and
follow those directions for downloading parameters.
•2. Note the two/three-character motor name on the label on the UniDrive
(Figure 19).
•3. Remove the UniDrive cover by pressing apart the inside bottom of the
cover (Figure 19) and pulling the cover towards you.
•4. Connect the communications cable (P/N EHE-4602-51) between the
software download port (Figure 19) and the serial port at the rear of the
laptop.
Note: Note the part number of the communications cable. Make sure that you use the
correct cable.
•5. Disconnect the CTNET cable.
•6. Insert the "hp indigo press whs software for w3200/ws4000" CD-ROM P/N
CA272-00041 into the laptop CD-ROM drive.
proprietary and confidential
Label
Software
download
port

Figure 19 UniDrive port

CA293-00600, Rev 00
CTNET port
Parameter
download
port
page 25 of 221