Front Light Group - VESPA LX 50 4V Manual

Front light group (03_28, 03_29, 03_30, 03_31, 03_32)

To access the headlight bulbs, remove the front of the handlebar cover, as follows:
1. Remove the rear-view mirrors.
2. Undo the three screws holding the handlebar cover, the two rear screws «A» and
the front screw «B». Once this has been done, the front handlebar cover can be re-
moved.
To replace the high-/low-beam headlight bulb:
1. Remove the rubber protection «C».
03_28
2. Unscrew the ring nut «D» to extract the bulb holder.
3. Press the bulb slightly and turn it anticlockwise to remove it.
To replace the tail light bulb:
1. Slide off the rubber bulb holder «E» from its fitting.
2. Hold and slide off the bulb.
N.B.
IF MISTING IS NOTICED ON THE INSIDE OF THE HEADLAMP GLASS, THIS
DOES NOT INDICATE A FAULT AND IS ATTRIBUTABLE TO HUMIDITY AND/OR
03_29
TO LOW TEMPERATURES.
THE PHENOMENON SHOULD QUICKLY DISAPPEAR WHEN THE LIGHT IS
SWITCHED ON.
THE PRESENCE OF DROPS OF WATER, ON THE OTHER HAND, COULD INDI-
CATE THAT WATER IS INFILTRATING. CONTACT THE AFTER-SALES SERVICE
NETWORK.
CAUTION
03_30
DO NOT CARRY ANY GARMENTS ON THE FRONT HEADLIGHT ASSEMBLY.
THIS MAY CAUSE BULBS TO OVERHEAT AND THEREFORE, TO WEAR AB-
NORMALLY.
48