Page 1
Montpellier Installation and Operating Instructions Model: TCS8 Free-Standing Condenser Tumble Dryer Please read these instructions carefully before attempting to install or use this appliance. It is advisable to keep these instructions in a safe place for future reference.
Page 2
Introduction Montpellier Thank you for choosing this appliance. It has been designed to give years of trouble-free use provided it is installed and maintained correctly. Please read these instructions carefully before installing or using your appliance. It is advisable to keep your purchase and installation receipts with these instructions in a safe place for future reference.
Page 3
Description of the Appliance 1. Control Panel 2. Drum Door 3. Adjustable Feet 4. Condenser Cover 5. Door ‘Push’ 6. Water Container Cover 7. Programme Control Knob 8. Display Panel 9. Function Buttons...
Page 5
Section 1. Installation Position the appliance in a dry, well ventilated room with a solid level floor. The room temperature must not fall below +5° or rise above +35°. This appliance is fitted with adjustable feet so that you can ensure it is sitting level.
Page 6
Section 2. Safety Advice This appliance is manufactured and intended for DOMESTIC use only. Any guarantee offered with the appliance is not valid for any installation in a commercial environment. This appliance MUST BE EARTHED! Never try and disconnect the power by pulling the supply cable – hold the plug firmly and pull it out of the socket.
Page 7
Section 3. Operating the Appliance 3.1. The Control Panel 3.1.1. Programme Selector Knob (A) The drying programme is selected by turning this knob (A) (See 3.2.2.) 3.1.2. Start/Pause Button (B) The drying programme is started or paused by pressing this button. The indicator lamp will flash during the selection phase and lights up during the drying programme (See 3.2.3.
Page 8
3.1.4. Display Panel & Indicator Lamps (H) The Display Panel (H) provides you with the following information: A ‘countdown’ display showing the remaining time the selected programme has left to run. A visual indicator showing when the filter requires cleaning (See Section 4.2.) However, you are advised to check and clean the filter at the end of every cycle.
Page 9
3.3. Programmes/Functions 3.3.1. Automatic Controlled Drying The appliance detects the moisture in the load and automatically adjusts the drying time. Simply select the programme according to the fabric type. 3.3.2. Time Controlled Drying Simply select the required time, 60’ or 90’ for cottons, or 30’ for synthetics and press the start button.
Page 10
3.3.7. Start/Pause Following selection of the programme and any relevant function, simply press the Start/Pause button (B) to start the cycle. You can pause the cycle at any time by pressing the button again. Press again to re-start. 3.3.8. Delay Function This function allows you to delay the start of a programme by up to 24 hours.
Page 11
3.3.12. After Each Use Clean the filter! Clean the condenser! Empty the water container! If the drying programme has to be stopped before it reaches the end, we recommend that that you turn the programme control knob to ‘Air Dry’ and wait until this programme has finished.
Page 12
3.3.14. Maximum Loads Recommended loads are indicated in the Programme Chart (3.3.13.) but the general rules are: Cotton/linen – full load but not tightly packed. Synthetics - drum no more than half full. Delicate fabrics and woollens – drum no more than quarter full.
Page 13
Section 4. Maintenance 4.1. Cleaning the Appliance Always switch off the power supply to the appliance before cleaning. Wash the exterior surfaces of the appliance with warm soapy water and dry thoroughly. Never use bleach or inflammable liquids. ...
Page 14
4.5. What to do if something goes wrong 4.5.1. Drier Does Not Work Ensure the plug is in the socket and the power is switched on. Check there is not a power cut Check the fuse in the plug (Must be 13 amp) ...
Page 15
Important Note: This appliance is marked according to the European directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE). By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product.
Need help?
Do you have a question about the TCS8 and is the answer not in the manual?
Questions and answers