Pc With Wi-Fi Adapter - D-Link DAP-1360U Quick Installation Manual

DAP-1360U

PC with Wi-Fi Adapter

1. Attach the antennas from the delivery package. To do this, remove the
antennas from their wrapper, attach them to the relevant connectors on the
back panel of the access point, and then screw the antennas in a clockwise
direction to the back panel. Position the antennas upward at their
connecting joints. This will ensure optimal operation of your wireless
network.
2. Connect the power cord to the power connector port on the back panel of
the access point, then plug the power adapter into an electrical outlet or
power strip.
3. Turn on the access point by pressing the ON/OFF button on its back
panel.
4. Make sure that the Wi-Fi adapter of your PC is on. As a rule, modern
notebooks with built-in wireless NICs are equipped with a button or
switch that turns on/off the wireless adapter (refer to your PC documents).
If your PC is equipped with a pluggable wireless NIC, install the software
provided with your Wi-Fi adapter.
Now you should configure your Wi-Fi adapter.
Quick Installation Guide
7