Advertisement
4.3 Drying times
A gross leak may still lead to water inside the unit. If this occurs, then disassemble the unit
and dry its component parts in an oven at +40°C to +60°C. Most parts will dry in a few hours,
However the battery pack traps water and should be left in the oven for at least 16 hours.
The oven is necessary, as the battery will not dry out if left at room temperature.
CAUTION - DO NOT EXCEED 70°C - RISK OF EXPLOSION
5. LABELLING.
5.1:
Fit the new battery date & over stick label, and check that serial number and TX ID is
still legible.
6. FINAL ASSEMBLY
6.1:
Fold the antenna around body & reattach the activation cap. The beacon will
activate. Switch off the beacon by pushing and holding the 'Off' button – the beacon
should switch off after approximately 3 seconds.
NOTE: Do not allow beacon to operate for longer than 15 seconds.
Orolia Ltd, Silver Point, Airport Service Rd, Portsmouth, Hants, PO3 5PB, United Kingdom
Tel: +44 (0) 23 9262 3900 Fax: +44 (0) 23 9262 3998 Email:
service.uk@mcmurdogroup.com
Page | 7
Advertisement
