Recording - Philips FW910SR/P22 User Manual

RECORDING

STEREO
OPTIMAL JAZZ
NEWS
REPLAY
DSC DBB
REPEAT SHUFFLE
PROGRAM TIMER
TECHNO ROCK
DIGITAL SOUND CONTROL
CD TUNER
CD 1 • 2 • 3 BAND
STANDBY . ON
DUBBING
TUNING
NORM•FAST RECORD A. REPLAY
SEARCH
OPEN OPEN
TAPE 1
26
RDS NEWS!
REC DBB
I S
HSD
INCREDIBLE SURROUND
FM MW LW AM PM MAX CLOCK
TIMER PROGRAM
MASTER VOLUME
TAPE AUX
TAPE 1 • 2 VIDEO
DEMO PRESET
PREV NEXT
STOP•CLEAR PLAY PAUSE
Notes:
– For recording, use only tape of IEC type I
(normal tape) or IEC type II (Chrome).
– The tape is secured at both ends with
leader tape. At the beginning and end
of tape, nothing will be recorded for six
to seven seconds.
– The recording level is set automatically,
regardless of the position of VOLUME,
n
DBB or Incredible Surround.
– To prevent accidental recording, break
out the tab on the left shoulder of the
tape side that you want to protect.
– If " CHECK TAPE " is displayed, the
OPEN OPEN
protection tab has been broken. Put a
piece of clear adhesive tape over the
opening. Do not cover the Chrome tape
detection hole when covering the tab
opening.
TAPE 2
One Touch Recording
• For One Touch Recording, as soon as you
press RECORD, the current source will
be recorded on tape deck 2.
1 Load a blank tape in tape deck 2.
2 Press RECORD to start recording.
™ REC flag starts flashing.
3 Press STOP Ç to stop recording.
Note:
– When you press RECORD at TAPE mode,
" SELECT OTHER SOURCE " will be
displayed. One Touch Recording is not
possible at TAPE mode.
Dubbing tapes
(from tape deck 1 to
tape deck 2)
1 Press TAPE to select tape deck 2 .
2 Load the prerecorded tape into tape
deck 1 and a blank tape into tape deck
2.
™ Make sure that the tape in tape deck
1 has its full spool to the left.
3 Press DUBBING once for normal
speed dubbing or twice within 2
seconds for high speed dubbing.
™ "NORMAL" (normal speed) or
"FAST" (high speed) will be
displayed and then followed by
"DUBBING".
™ HSD flag appears on the display for
high speed dubbing.
• Dubbing will start immediately.
™ REC flag starts flashing.
4 Press STOP Ç to stop dubbing.
Notes:
– At the end of side A, flip the tapes to
side B and repeat the procedure.
– Dubbing of tapes is only possible from
tape deck 1 to tape deck 2.
– To ensure good dubbing, use tapes of
the same length.
– During high speed dubbing in Tape
mode, the sound is reduced to a low
volume.
– You can switch to other source while
dubbing.