Philips FW910SR/P22 User Manual page 7

A AM Loop Antenna
Connection
Connect the supplied loop antenna to the
AM AERIAL terminal. Place the AM loop
antenna far away from the system and
adjust its position for the best reception.
B FM Wire Antenna
Connection
Connect the supplied FM wire antenna to
the FM 75 terminal. Adjust the position
of the FM antenna for the best reception.
Outdoor Antenna
For better FM stereo reception connect an
outdoor FM antenna to the FM AERIAL 75
terminal using a 75 coaxial wire.
C Speaker Connections
• Connect the right speaker to Front
terminal R, with the colored wire to +
and the black wire to -.
• Connect the left speaker to Front
terminal L, with the colored wire to +
and the black wire to -.
• Clip the stripped portion of the speaker
wire as shown.
12 mm
unlock lock
D CD Recorder Connections
ANALOG CONNECTIONS
Connect the red plugs to the R sockets, and
the white plugs to the L sockets.
For recording
Connect cable between the ANALOG IN-
sockets on the CD recorder CDR LINE- or
TAPE OUT-sockets of an amplifier.
Note:
– For recording directly from a CD player,
the analog input of the CD recorder
should be connected to the analog
output of the CD player.
For playback
Connect cable between the ANALOG OUT-
sockets on the CD recorder and the AUX IN
sockets on the mini system, or the input
sockets of an amplifier e.g. TAPE IN, CDR
or AUX.
Note:
– Never use the PHONO input.
DIGITAL COAXIAL CONNECTIONS
For recording
Connect the cable between the DIGITAL IN-
socket on the CD recorder and the DIGITAL
OUT-socket of the mini system or CD
player.
For playback
Connect the cable between the DIGITAL
OUT-socket on the CD recorder and the
digital coaxial input of an amplifer or
recording device.
Note:
– Digital coaxial connection is only
required in case you wish to record from
a CD player with digital coaxial output.
DIGITAL OPTICAL CONNECTIONS
For recording
Connect a fibre-optic cable (not supplied)
between the IN OPTICAL of the CD
recorder and the digital-optical output of a
CD player.
Notes:
– Digital optical connection is only
required in case you wish to record from
a CD player with digital optical output.
– For playback, the digital coaxial output
or analog output should be connected to
an amplifier.
– When connecting the Digital Optical
cable, make sure it is fully inserted until
there is a click.
PREPARATION
E Subwoofer Out Connection
Connect the optional active subwoofer to
the SUBWOOFER OUT terminal. The
subwoofer reproduces just the low bass
effect (e.g. explosions, the rumble of
spaceships, etc.). Be sure to follow the
instructions supplied with the subwoofer.
F AC Power Supply
After all other connections have been
made, connect the AC power cord to the
system and to the wall outlet.
Inserting batteries into the
Remote Control
• Insert the batteries (Type R06 or AA)
into the remote control as shown in the
battery compartment.
• To avoid damage from possible battery
leakage, remove dead batteries or
batteries that will not be used for a long
time. For replacement, use type R06 or
AA batteries.
7