I/O Connectors; Rear I/O Ports - DFI GHF51 User Manual

Assembly
X
S i d e
e t a l
e M
r f a c
I n t e
Rotate the module and heat spreader combo so that the I/O is facing the desired side, and
place the combo in the position of the chassis reserved for your module.
Align the screw holes of the combo to those on the chassis. The combo can be mounted onto
the chassis in two manners — 1) module side to the chassis, or 2) heat spreader side to the
a l
M e t
a c e chassis as illustrated below. This shall depend entirely on the design of the chassis with regard
to interior spacing, thermal, and I/O.
Place the screws that come with the standard package into the screw holes, and use a screw
U p
S i d e
driver to fasten the screws until the combo is securely fixed onto the chassis.
C P U
„ Module side to the chassis
s i s
h a s
T o C
Note:
An optional heatsink can be purchased as an alternative to the heat spreader. The
heatsink comes with attached spring screws and is fairly intuitive in terms of in-
stallation.
User's Manual | GHF51
s i s
h a s
n
D o w T o C
„ Heat spreader side to the chassis
T o C
X I/O Connectors

Rear I/O Ports

s i s
h a s
Features
• Intel
I210IT PCI Express Gigabit Ethernet controller)
• 2 x Micro HDMI with resolution up to 4096x2160 @ 24Hz
HARDWARE INSTALLATION
Bottom View
„ LAN
„ Micro HDMI 2
„ USB 3.1 Gen 2, Type C
I211AT PCI Express Gigabit Ethernet controller (alternatively Intel
®
Chapter 2
„ Micro HDMI 1
®
10