Download Print this page

Camec ELITE EM303 User Manual page 4

Caravan mover

Advertisement

4
INTRODUCTION
Congratulations on choosing the Camec Elite
produced according to very high standards and has undergone careful quality control procedures.
By using the remote control handset you can move your caravan effortlessly into any position required within
operating guidelines. Soft start and soft stop technology allows you to manoeuvre your caravan accurately
without any shocks.
The caravan manoeuvring system consists of two 12V motor-power rollers, a 12V electronic control unit and a
remote control handset. To function, the motor-powered rollers must be engaged against the tyres of your
caravan. The supplied cross actuation device enables you to engage both rollers at the same time from one side
of your caravan. Once this is done the manoeuvring system is ready for operation. The remote control will allow
you to move your caravan in any direction. You can even rotate the caravan on it's own axis, without moving
forwards or backwards.
Before proceeding with installation and starting to use the manoeuvring system, please read
this manual very carefully and be aware of all the safety instructions! The owner of the
caravan will always be responsible for correct use. Keep this manual inside your caravan for
future reference.
INTENDED USE
The Camec Elite
®
EM303 caravan manoeuvring system is suitable for single axle and double axle caravans.
Suitable only for L-profiled and U-profiled chassis with a chassis thickness between min. 2.8mm and max.
3.5mm.
Depending on the weight of the caravan, the manoeuvring system cannot overcome obstructions that are more
than about 2cm in height without assistance (please use wedges as a ramp).
The standard installation kit only provides parts for installing the caravan manoeuvring system within the
measurements given in Fig. 16.
SPECIFICATIONS
Designation
Operational voltage
Average current consumption
Maximum current consumption
Transmitting frequency remote control
Speed
Weight (2 motor set)
Permissible overall Weight single axle (2 motors)
Permissible overall Weight double axle (2 motors)
Permissible overall Weight double axle (4 motors)
Minimum width (caravan/trailer)
Maximum width (caravan/trailer)
Maximum tyre width
Power source (battery)
INSTALLATION - SAFETY GUIDELINES
Read this user manual carefully before installation and use. Failure to comply with
these rules could result in serious injury or damage to property.
These symbols identify important safety precautions. They mean CAUTION! WARNING!
SAFETY FIRST! IMPORTANT INFORMATION!
Before starting installation under the caravan:
Check the towing load of your vehicle and the gross weight of your caravan in order to establish whether they
are designed for the additional weight. The manoeuvring system itself has a weight of about 37kg and a battery
has a weight of about 20-25kg.
Check the minimal installation dimensions of the manoeuvring system based on figure 16.
®
EM303 caravan manoeuvring system. This has been
Camec Elite
12 Volt DC
20 Ampere
100 Ampere
868MHz
approx. 9cm per sec.
approx. 37kg (exclusive battery)
1800kg (1500kg on 18% gradient)
1800kg (1500kg on 18% gradient)
2500kg (1800kg on 18% gradient)
1800mm
2500mm
205mm
LiFePO
: 12V, 20Ah (recommended Camec Elite
4
EM303) Lead acid: 12V, 80Ah (min.)
CAMEC ELITE
"More information https://www.caravansplus.com.au"
EM303
®
Ref: ELITE EM303-0814-Rev.A.
EM303
®

Advertisement

loading