Programming The Disc Tracks; Erasing The Programme - Philips FWC170/19 User Manual

Programming the disc tracks

Programming tracks is possible when playback is
stopped. Up to 40 tracks can be stored in the
memory in any order.
1
Load the desired discs on the disc tray (refer to
"Loading discs").
2
Press PROGRAM to start programming.
➜
starts flashing.
PROG
3
Press CD 1/2/3 to select a disc.
4
Press í or ë repeatedly to select the desired
track.
5
Press PROGRAM to store the track.
G Repeat steps 3–5 to store other discs and
tracks.
6
To end programming, press Ç once .
➜
stays and the programme mode
PROG
remains active.
➜ The total number of tracks programmed and
the total playing time are displayed.
7
To start programme play, pressÉ Å .
➜ "PLAY PROGRAM" is displayed.
Notes:
– If the total playing time is more than "99:59"
or if one of the programmed tracks has a number
greater than 30, then "--:--" is displayed
instead of the total playing time.
– If you attempt to programme more than 40
tracks, "FULL" is displayed.
– During programming, if no button is pressed
within 20 seconds, the system will exit the
programme mode automatically.
To review the programme
G Stop playback and press í or ë repeatedly.
G To exit review mode, press Ç.
CD Operation

Erasing the programme

G Press Ç once when playback is stopped or
twice during playback.
➜ disappears and "PROGRAM CLEARED"
PROG
is displayed.
Note:
– The programme will be erased when the system
is disconnected from the power supply or when the
disc tray is opened.
For Recording, please refer to "Tape
Operation/Recording".
17