Changing The Memory Bank (Fm); Storing Stations; Storing The Strongest Stations Automatically With Travelstore; Recalling Stored Stations - Blaupunkt BARCELONA RCM 104 A Operating Instructions Manual

Changing the memory bank (FM)

You can shift between the memory banks I, II,
and "T" to store and to recall preset stations.
The selected memory bank is indicated in the
display.
• Press FM until the desired memory
T
bank lights up in the display (press re-
peatedly if necessary).

Storing stations

Using the preset buttons 1, 2, 3, 4, 5, 6 you
can store six stations on each FM memory
bank (I, II, T).
In the MW/LW range you can store six stati-
ons each.
• Select the waveband with the FM
M•L button.
• Select a station with the rocker switch
(either automatically /
<< >>).
• Press the desired preset button and
hold it down. The radio will be muted
and resumes play after approximately 2
seconds.
Now the station has been stored. The activa-
ted preset button is indicated in the display.
Note:
Should you tune into a station which has
already been stored, the corresponding pre-
set button and the memory bank will start
flashing in the display for a short while, if you
have selected another memory bank.
Storing the strongest stations
automatically with Travelstore
You can use the Travelstore memory bank to
automatically store the six strongest FM sta-
tions sorted on the preset buttons according
to their signal strength. This feature is espe-
cially useful when travelling, because it will
always give you the most powerful stations at
a finger tip as you pass through the various
or
T
reception areas.
• Press FM
The radio will search for the six most powerful
or manually
FM stations and store them on the "T" memo-
ry bank (Travelstore). When this process has
been completed, the radio will tune in the
strongest station.
FM stations can also be stored manually on
the Travelstore memory bank (see "Storing
stations").
for approximately 2 sec.
T

Recalling stored stations

You can recall any stored station by pressing
the corresponding preset button.
• Press FM or M•L to select the wave-
T
band. For FM, also choose the corre-
sponding memory bank by pressing
FM until the desired bank is indicated
T
in the display.
• Briefly press the corresponding preset
button.

Preset scanning

You can have all of the stations stored in one
waveband scanned by using the Preset Scan
function. Choose the desired SCANTIME in
the DSC menu.
• Briefly press PS.
All of the stations in that waveband will
be scanned one after another.
Depending on which memory bank has been
activated for FM, all of the stations in either I,
II or the Travelstore level will be scanned. If
a preset is not in use, it is skipped.
To stop the scan:
• Press the PS button once again.
The radio will continue to play the cur-
rently scanned station.
35