Reg - Regional; Selecting The Waveband; Automatic Seek Tuning; Manual Seek Tuning - Blaupunkt BARCELONA RCM 104 A Operating Instructions Manual

Should the reception quality of the selected
program become too bad,
• tune into another program.

REG - Regional

Certain radio programs are split up at times
into regional programs offering local informa-
tion. If you are listening to one program and
move to an area where another linked regio-
nal program becomes stronger, the unit will
switch to that program. If you wish to continue
listening to the first station:
• Press the AF button for about 2 sec.
The display will show "REG ON".
If you leave the service area of the regional
station tuned into, or if you would like to take
advantage of the full RDS service, then
switch to "REG OFF".
• Press the AF button for about 2 sec.
until "REG OFF" is displayed.
The display will show "REG ON" or "REG
OFF" every time the radio is switched on.

Selecting the waveband

This car radio can be used in any of the three
following wavebands:
FM 87.5 - 108 MHz
MW 531 - 1602 kHz, and
LW 153 - 279 kHz
34
• Select the desired waveband by pres-
sing the FM or M•L button.
T
To switch between MW and LW:
• press M•L.

Automatic seek tuning

/
• Press / . The radio will automatically
tune into the following station.
If you keep the upper or lower part of the
rocker switch / depressed, seek tuning
speeds up in upwards or downwards direc-
tion.
up
down in short
intervals
(when AF is off)
down
Manual seek tuning << >>
Prerequisite: AF is switched off!
• Press << or >> to change the frequency
in small steps in upwards/ downwards
direction.
If you hold down the right or left part of the
rocker switch, then the car radio will move
through the stations quickly.
Adjusting the seek tuning sensi-
tivity
The set allows you to modify the seek tuning
sensitivity.
If "lo" is indicated, the radio will only pick up
strong stations (low sensitivity).
If "lo" is deactivated, the radio will also pick up
less powerful stations (higher sensitivity).
The degree of sensitivity can be separately
adjusted for both levels (see chapter "DSC
programming").

Stereo - mono switch (FM)

If reception is poor, you may get better sound
quality if you switch to mono:
up in short
• Press lo for approximately 2 seconds.
intervals
The stereo symbol
(when AF is off)
playback.
Each time the car radio is switched on, stereo
playback is activated.
The unit will automatically switch to mono
playback under poor reception conditions.
will disappear for mono